Set of diamond sharpening stones TSPROF Alpha SD126 - SD3 (7 pcs.)

Set of diamond sharpening stones TSPROF Alpha SD126 - SD3  (7 pcs.)

TSPROF Alpha are unique rubber-bonded diamond stones that perform incredibly cleanly. Through many experiments, we were able to achieve the ideal combination of binding agent and optimal concentration of abrasive particles. As a result, TSPROF Alphas operate very cleanly and have the highest wear resistance.

TSPROF Alpha diamond stones can easily cope with any steel with a hardness of up to 70 HRC.

Each bar undergoes careful preparation and does not require opening, which ensures minimal variations in thickness within ±0.1 mm.

To ensure reliable fixation in the abrasive holder, TSPROF Alpha is glued to an aluminum form with 45° bevels. The blanks are anodized red*.

The bars are packed in individual blister packaging.

The set includes bars: 

TSPROF Alpha 125/100 (120 grit) is designed for roughing and rough sharpening of cutting edges.

TSPROF Alpha 80/63 (180 grit) is designed for coarse sharpening of the cutting edge.

TSPROF Alpha 40/28 (360 grit) is intended for basic sharpening of the cutting edge.

TSPROF Alpha 20/14 (1000 grit) is intended for basic sharpening of the cutting edge.

TSPROF Alpha 10/7 (2000 grit) is designed for pre-finishing of the cutting edge.

TSPROF Alpha 5/3 (5000 grit) is designed for finishing cutting edges

TSPROF Alpha 2/1 (11000 grit) is designed for finishing and polishing cutting edges

Characteristics:

Length: 150 mm

Width: 25 mm

Thickness: 3mm ± 0.15mm

Bond: rubber

Due to the peculiarities of production, the width and length of the abrasive may differ from the values ​​​​specified in the description by up to 5% . 

*Due to the peculiarities of the anodizing technological process, the shades of the forms may vary slightly.

Recommendations for use:  It is recommended to use TSPROF sharpening oil.

Attention!  The whetstones require careful handling: do not put pressure on the abrasive during sharpening (especially when sharpening the tip/edge of the knife), do not allow the whetstone to fall off the plane of the blade or fall onto a hard surface.